MEU CARRINHO
O meu Carrinho está vazio

TV Modulator: Terra MT-21P (G,K: ch.21-69, with AC/DC adapter)
Código: R871721
Produto Descontinuado
Base Unit UC-380 (for Modular Headend MMH-3000)
View of the modulator

Base Unit UC-380 (for Modular Headend MMH-3000)
...and the view after removing the flap

Base Unit UC-380 (for Modular Headend MMH-3000)
Top view. The push-buttons "+" and "-" are used for setting output channel. The left side pot underneath sets proper deviation of sound subcarrier, and the right lower corner pot - RF output level.


Base Unit UC-380 (for Modular Headend MMH-3000)
Terminating load and mounting screws included

Output level adjustment allows to match the signal to other signals within the installation, also concerning other modulators connected in cascade.
50 kHz is the standard deviation for input audio signal of 0.775 V RMS. The adjustment of deviation ensures similar deviation for a little different audio levels. The standard deviation can be obtained within the range of 0.150-0.775 V . Correct adjustment is essential for equal volume levels on individual TV channels.
Switching on the power, with pressed one/two of the keys on the modulator, will allow to set some other parameters:

During switching on key "-"

is being pressed

During switching on key "+"

is being pressed

During switching on both keys "-" and "+" are being pressed
Possibility of setting sound standard 6.5/5.5 MHzPossibility of setting video modulation factor +/-6% at 2% intervalsPossibility of setting output frequency +/-2.5MHz at 250kHz intervals
The standard depth of video modulation is 75%, however sometimes it can be useful to change it a little, e.g. when the source generates alphanumeric characters a bit exceeding proper limit. The possibility of setting video modulation factor within +/-6% enables correction in such cases, optimizing the signal quality. In practice it is seen as little change of brightness and contrast of the picture, e.g. of that characters. Generally, when the original and converted (by the modulator) picture has regular quality (no overmodulation), and sound is clear as well - no correction is needed.
Changing a little output frequency one may attempt to eliminate interferences coming from neighboring channels, when they are fixed in the system. Making offset of the output modulator's frequency there is a chance to solve that problem. The possible range is +/-2.5 MHz at 250 kHz intervals. Generally, when the signals within installation are of good quality, that feature is not used.
Main features:
  • two standards (G, K),
  • PLL synthesis,
  • protection against tampering,
  • DSB-type,
  • RF loop,
  • F-type connectors (output, input) and RCA sockets (audio & video inputs).
To sum up - the TV standard and channel are set in "soft" way using keys and the display. Sound deviation and output signal levels are set with pots. Additionally, there can be done some signal corrections, described above (see the pictures).
Specifications
Name

Modulator MT-21P

Code R871721
Video baseband
Hz20...6M
Video input level (tolerance)/impedanceV+/-dB@ohm1 (+/-1) / 75
Audio baseband
Hz20...15k
Audio input level/impedance/deviation

mV RMS/
kohm/kHz
775/
10/50
Audio input signal level adjustment
dB+1...-14
Typical RF output signal level/impedancedBuV/ohm85/75
RF output level adjustment dB 0...-15
Output channel range
 21-69
RF carrier deviation
kHz
+/-50
Sound standards
 G,K mono (5.5, 6.5 MHz)
RF carrier offset
MHzmax +/- 2.25. with 0.25 step
A/V ratio (switchable)dB
-12/ -16
Modulation factor %81
S/N ratio (weighted)
dB >=58
II, III order intermodulation distortionsdB<-60
PowerV/Hz/VA230/50/5
Operating temperatureoC-10...+50
Dimensions/Weightmm/kg78x118x47/0.37
Produto Descontinuado
 
TV Modulator: Terra MT-21P (G,K: ch.21-69, with AC/DC adapter)
Código: R871721